Artigo : A low-cost small-size commercial PIN photodiode: I. Electrical characterisation and low-energy photon spectrometry

A low-cost small-size commercial PIN photodiode: I. Electrical characterisation and low-energy photon spectrometry
 

Malafronte, A. A., Petri, A. R., Gonçalves, J. A. C., Barros, S. F., Bueno, C. C., Maidana, N. L., Mangiarotti, A., Martins, M. N., Quivy, A. A. and Vanin, V. R.
Radiation Physics and Chemistry 179, 109103 (2021)


DOI : 10.1016/j.radphyschem.2020.109103

 

Abstract

Silicon PIN (p-type-intrinsic-n-type) photodiodes are well suited as particle detectors. Here the interest is on a low-cost solution by repurposing a commercial device meant to be used as a light sensor. The intended application is to measure the energy spectra of electrons scattered by thin metallic foils covering small angles close to the beam of the accelerator. The main requirements for a suitable device are: 1) a low-cost solution to allow frequent replacements; 2) a small size to avoid as much as possible an unused area that contributes with unnecessary capacitance; 3) a good energy resolution; and 4) an easy repurposing as a charged-particle detector. The photodiode type BPX 65 manufactured by Osram® fulfils well these requirements. Four samples of these commercial devices have been electrically characterised with respect to reverse current and depleted-region capacitance. At the selected working point of 18 V, comfortably below the maximum rating of 20 V recommended by the manufacturer for continuous operation, the total thickness of the depleted and intrinsic regions is estimated to be (60 ± 3) μm. For the four samples considered, the measured reverse currents for a reverse bias of 18 V are around 0.1 nA, well below the typical value specified by the manufacturer (1 nA). To evaluate the performance of the device as a detector, energy spectra have been acquired for γ-rays with energies from 10 to 140 keV using 241Am, 133Ba, and 57Co radioactive sources. The resolution of the BPX 65 encountered with the γ-rays emitted by 241Am at 59.5-keV is ≈ 2.5 keV (FWHM - Full Width at Half Maximum), which is close to the value obtained with a pulser, showing that its main limitation is the electronic chain employed in the setup. The response function to monoenergetic electrons in the same energy range is studied in the companion paper.